Getting ready for the Trondheim Maker Faire

Last preparations for the upcoming Trondheim Maker Faire 2014. In order to display the Raspberry Pi / Teensy 3.1 based submersible ROV, I bought a used 3m diameter inflatable pool. This should give us enough space to demonstrate the little buddy.

The ROV got a slight face-lift by adding proper motor-pods and casings for the cables. The ballast stones tied to the bottom got replaced by a rusty old chain in casings. Better solution pending …

RaspiTeensyROV under Water RaspiTeensyROV - front RaspiTeensyROV after Test Clas Ohlson Pool (3m)

See you at the Trondheim Maker Faire booth 10a: Map of the Faire

Leave a Reply

Your email address will not be published. Required fields are marked *